Cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Fitbit sense stuck in reboot

Replies are disabled for this topic. Start a new one or visit our Help Center.

My Fitbit sense is stuck in a loop, showing the Fitbit logo and then rebooting. I can't get it to reset or pair with the phone app again.

Best Answer
0 Votes
7 REPLIES 7

Mine did the exact same thing, I got a warranty claim, they asked me to send it back, and it's been over two weeks without any replacement even sent. I'd suggest just getting a chargeback and finding a competitor. Wish I'd done that.

Best Answer

Mine is doing same thing what do I need to do only had it for 3 months

Best Answer
0 Votes

Your best bet may be to contact  Customer Services Margie, through the Fitbit homepage who should be able to help.

Best Answer

Mine did the same thing.   Were you using a different watch face than the Fitbit defaults?  I am wondering it they could cause the Sense to be unable to boot up if they are buggy. 

Best Answer
0 Votes

All,

 

I was using the Light watch face, which it a Fitbit-developed face. I contacted support and they sent a replacement. If you're having a similar problem, contact them -- they can walk you through possible fixes and arrange for the replacement if you're eligible.

Best Answer
0 Votes
Mine finally rebooted 


Sent from Yahoo Mail for iPhone
Best Answer

Don’t plug the Fitbit device into the charging cable. Press and hold the button for about 8 seconds until the screen turns off. After the screen turns off, you'll feel a short vibration: When you feel the vibration, release the button and immediately press and hold the button again. Wait until the blue logo appears, then disappears: Immediately release the button and then immediately press and hold it .again, until you feel a vibration. After you feel the vibration, release the button. This vibration indicates you started the factory reset. Wait for approximately 12 minutes while the device clears all data. Eventually, the Fitbit logo appears and the device boots and displays Fitbit.com/setup  Wait for a couple of minutes. wait until the Fitbit logo comes back with different languages. You just have to setup it up on your phone again just like you did the first time you setup the Fitbit. On the setup page, you will see the "Replace". Tap that then proceed. During setup, it will ask you to update the firmware that will take a while. But after that, you are all set. I hope this helps.

Best Answer